What is routerlogin.net?

Routerlogin.net is the web domain used for logging in to the router’s web-based setup interface. This interface or the admin setup page can be easily accessible by entering the web domain routerlogin.net in the URL bar of the browser.

The users, however, can also log in to their router’s setup window through the default IP address of the router i.e. 192.168.1.1 or 192.168.0.1.

Is it possible to access the Netgear router setup page through a method except for the routerlogin.net?

Yes, you can log in to the Netgear router setup through its default IP address i.e. 192.168.1.1 or 192.168.0.1. It is not mandatory to log in to the router’s page through the web domain www.routerlogin.net but this web address routerlogin.net was developed for the convenience of the users.

What to do if am not being able to access the router setup portal or my browser shows “page can’t be loaded” error?

This error is most likely to occur when you have not set up the connection between the modem, router and the computer properly. Make sure that Ethernet cable connections are made properly and the power supply to the router/modem and the computer is on. Also, try to reboot your computer and make sure that you are using the latest and updated web browser.

What is the default IP address of the router?

The default IP address of the router is actually a by default numerical web domain which is addressed only to get access to the router firmware. This web address http://192.168.1.1 or http://192.168.0.1 doesn’t require an internet connection; however, a basic LAN setup is required.

Where can I find the IP address of my router?

The IP address of a particular router is usually written on the label of the router which is pasted on the upper or lower body of the router. You can also obtain the router’s IP address by launching the command of IPCONFIG in your command prompt window.

What connection type should be selected while setting up the Internet connection on my router?

There are several connection types in the drop-down list of the Internet settings tab. The user is required to select the PPPoE connection type. PPPoE connection type works best for the Internet supply and it stands for point to point protocol over Ethernet.

How to reset the router through the factory reset button?

The factory reset button is given on the back panel of the router and it is situated deep inside a pinhole. Just insert a pin inside the pinhole and push the reset button. Keep the button pushed for at least 3-5 seconds or till the router doesn’t reboot. In this way, your router will get reset back to its original factory settings.

Do we need to configure the router again for the internet service after reset?

Yes, of course, you will be required to perform the router configuration again if you have reset the router to its original factory state. Resetting basically erases all the important and crucial configuration information from the router and it gets back to the default settings.

How to update the firmware of the Netgear router?

The firmware of the Netgear router can be easily updated in few easy steps. Just follow the below-mentioned steps.

  • First of all download and save the Netgear firmware update file from the Netgear support portal.
  • Then access the Netgear router setup page and click the firmware update tab to select the update file from your PC.
  • On selecting and opening the update file, the update installation process will start automatically. Follow rest of the instructions on the screen to complete the firmware update process.

Why do we need to update the firmware of the router?

The update in the firmware of the router usually brings in some positive and effective changes to the router. The update in the firmware of the router adds and enhances the router security, some more parental controls are added and the router interface usually gets better by getting more tabs and buttons on it.